Speaker Installation Option - Panasonic SC-BTT465 Owner's Manual

Speaker installation
option
Consult a qualified building contractor when
attaching the speakers to a wall. Improper
attachment may result in damage to the wall and
speakers and personal injury.
Attaching to a wall
You can attach all of the speakers (except
subwoofer) to a wall.
≥ The wall or pillar on which the speakers are to
be attached should be capable of supporting
10 kg per screw.
1
Drive a screw (not supplied) into the wall.
A At least 30 mm
B ‰ 4.0 mm
C ‰ 7.0 mm to
‰ 9.4 mm
D Wall or pillar
E 5.5 mm to 7.5 mm
2
Fit the speaker securely onto the screw(s)
with the hole(s).
e.g., [BTT465] [BTT405] Surround speaker
DO NOT
≥ In this position, the
speaker will likely fall if
moved to the left or right.
Screwing positions on the
wall
Use the measurements indicated below.
≥ Leave at least 20 mm of space above the
speaker and 10 mm on each side to allow
enough space for fitting the speaker.
[BTT465] [BTT405] CENTER
A 14 mm
B 65 mm
C 175 mm
32
VQT5F59





DO
≥ Move the speaker so
that the screw is in this
position.



[BTT465] FRONT
Attach to a wall without the base and the stand.
≥ Before using the speaker cable, remove it from
the stand by pulling it out.
D 45 mm
E 53 mm
F 266 mm
≥ Reattaching the speaker cable to the stand
Straighten the cable and run through the stand.
Pull out the cable through the hole.
[BTT465] SURROUND
[BTT405] FRONT, SURROUND
[BTT105] FRONT
G 42 mm
H 45 mm



160 mm

