Troubleshooting Guide - Panasonic SC-BTT465 Owner's Manual

Troubleshooting guide

Reference
Before requesting service, please perform the
following checks.
If the problem remains unresolved, consult
your dealer for instructions.
∫ Unit does not respond to remote
control or unit's buttons.
Disconnect the AC mains lead, wait 1 minute,
then reconnect the AC mains lead.
Do you have the latest firmware installed?
Panasonic is constantly improving the unit's
firmware to ensure that our customers are
enjoying the latest technology. (
The following do not indicate a problem with
this unit:
– Regular disc rotating sounds.
– Image disturbance during search.
– Image disturbance when replacing 3D discs.
∫ Cannot eject disc.
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
j"00rEt" is displayed on the unit's display.
3 Press [1] (right) repeatedly on the remote
control until "06FtO" is displayed on the unit's
display.
4 Press [OK].
34
VQT5F59
To return to the factory defaults.
Select "Yes" in "Default Settings" in the Setup
menu. (
To return all settings to the factory preset.
Reset the unit as follows:
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
j"00rEt" is displayed on the unit's display.
3 Press [1] (right) repeatedly on the remote
14)
control until "08FIn" is displayed on the unit's
display.
4 Press and hold [OK] for at least 5 seconds.
The remote control does not work properly.
Change the batteries in the remote control.
(
Depending on the condition of the unit,
[SELECTOR] and [
Display the HOME menu and try again.
The TV tuner mode is not displayed when the
TV is turned on.
This phenomenon may occur, depending on the
TV setting, when "Quick Start" is set to "On".
You have forgotten your ratings password.
You want to cancel the ratings level.
The ratings level returns to the factory
defaults.
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
j"00rEt" is displayed on the unit's display.
3 Press [1] (right) repeatedly on the remote
control until "03 VL" is displayed on the unit's
display.
4 Press [OK].
General operation
31)
9)
] may not respond.