Volvo S60 Owner's Manual page 218

05 Comfort and driving pleasure
Trip computer
Average fuel consumption
Current fuel consumption
Current fuel consumption
-
Scroll among the trip computer information
headings at any time by turning the thumb
wheel until the desired heading is displayed.
05
Supplementary information
Average fuel consumption
Fuel consumption since the last time this
function was reset.
Average speed
The vehicle's average speed since the last
time this function was reset.
Current fuel consumption
Current fuel consumption is calculated
approximately once a second. When the vehi-
cle is moving at low speed, fuel consumption
is displayed per unit of time. At higher
speeds, it is displayed in terms of distance.
*
216
Option/accessory, for more information, see Introduction.
Heading combinations
Trip odometer T1 + mileage
Trip odometer T2 + mileage
Mileage
No trip computer informa-
tion displayed
Miles or kilometers can be displayed, see the
heading "Changing units" on page 217
Distance to empty
This function shows the approximate dis-
tance that can be driven on the fuel remaining
in the tank. When
"----", there is very little useable fuel remain-
ing in that tank; refuel as soon as possible.
The calculation is based on average fuel con-
sumption during the last 20 miles (30 km) of
driving and the amount of fuel remaining in
the tank (the accuracy of this figure may vary
if your driving style changes). An economical
driving style will generally increase this dis-
tance.
See page270 for information about driving
economically.
Description
•
Press and hold RESET to reset trip odometer T1.
Average speed
•
Press and hold RESET to reset trip odometer T2.
Distance to empty
mph<>kmh Change between mph<>kmh – see "Digital speed display" on
page 216.
- No information will be displayed. This also indicates the begin-
ning/end of the list of information headings.
Distance to empty
shows
Digital speed display*
Speed is expressed in the unit not used by
the instrument panel's speedometer e.g., if
the normal speedometer is in mph, the trip
computer will display in the speed in km/h
and vice versa.
Resetting an analog instrument panel
Trip odometer(s) and average speed
1. Display trip odometer T1 or T1, or Aver-
age speed.
2. Press and hold RESET until selected
function is reset.
Each trip computer heading must be reset
individually.