Programming Remote User Passwords - Lucent Technologies DEFINITY Administrator's Manual

Password Programming
3. At the "Enter Password" screen, enter your system
administrator password, and press the Drop button on the
telephone. A valid password must be entered to allow the
telephone to be connected to the PBX.
NOTE:
If this is the first time you are entering your system
administrator password, the default is "00000000." All Remote
Module user passwords are disabled as a default.
!
Security Alert
Change your password as soon possible and store the new
password in a secure place.
4. If a valid password has been entered, the Remote Module
completes the connect sequence and the telephone
isoperational. If an invalid password has been entered, you are
prompted to re-enter the password. If after three attempts a
valid password has not been entered, the Remote Module
disconnects and the "Go Online?" prompt is displayed.

Programming Remote User Passwords

Up to 100 passwords can be programmed into the Switch Module.
This allows a number of different users to access the Switch
Module at different times. However, only one Remote Module user
can be connected to an individual Switch Module at any one time.
:
Issue 3 July 1997
2-7