Maintenance Menu Operations - Sony PDW-1500 Operation Manual

Item
SDI2 SUPER
For details about OTHERS items other than the above,
refer to the Maintenance Manual.

8-4-2 Maintenance Menu Operations

This section describes the indications in the maintenance
menu and how to change the settings.
To display a menu item setting
First change the switch setting within the unit, then carry
out the following operations.
For information about how to change the switch setting
within the unit, see page 109.
REMOTE [9P iLINK]
SG DATA SG DATA SG DATA SG DATA EDIT
ACCESS ANA SDI ANA SDI ANA SDI ANA SDI
INPUT
AE8/EBU AE8/EBU AE8/EBU AE8/EBU VITC VIUB
i.LINK
dB dB dB dB
OVER OVER OVER OVER
0 0 0 0 SDI
CMPST
NETWORK -12 -12 -12 -12 Y-R,B
LOCAL -20 -20 -20 -20 SG
REMOTE -30 -30 -30 -30 HOURS
-40 -40 -40 -40 MONITOR
MONITOR
-60 -60 -60 -60 1/2 3/4 AUDIO
CH- 15 CH- 26 CH- 37 CH- 48 5/6 7/8 4 8 CH
L
MIX
R AUDIO VIDEO
MONITOR SEL METER SEL INPUT CH INPUT SEL INPUT SEL
ALL/CH-1 CH-2 CH-3 CH-4
VARIABLE
REC
PRESET
PB
PHONES NEXT
PREV PLAY STOP
TOP F REV F FWD END
1
Press the MENU button.
The menu appears in the time data display.
2
Hold down the COUNTER SELECT button, and press
the SET button.
In the time data display, first "MAINTE MENU"
appears momentarily, and then the item group name
appears.
To change the item group
Use the F/f buttons.
3
Press the g button.
Setting
Select whether to output superimpose characters to the SDI OUT2 (SUPER) connector.
ON: Output.
OFF: Do not output.
1
EJECT
KEY INH ALARM
COUNTER VITC REC INH
MINUTES SECONDS FRAMES
625 IMX[50 40 30]
18 24 BIT 525 DVCAM
SHIFT
COUNTER SYS MENU
SELECT HOLD MENU
SUB THUMB
CLIP NAIL SET RESET
CLIP ESSENCE S.SEL
MARK1
MENU MARK
REC
IN OUT
MARK2
2 2,3 3,4
OTHERS
The item name appears.
Flashes to indicate that there is a next level (sub-item/setting).
To return to the item group
Press the G button.
To change the menu item
Use the F/f buttons.
4
Press the g button.
The setting value appears.
To return to the menu item
Press the G button.
When there is a sub-item
Repeat step 3.
To display the menu on a monitor
Connect the monitor to the VIDEO OUT 2 (SUPER)
connector or SDI OUT 2 (SUPER) connector of this unit,
and carry out the same operation as in the previous item.
The currently selected menu item is shown in reverse
video on the monitor.
To change the setting of a menu item
To change the setting of the currently displayed menu
item, carry out the following operations.
For details of changing settings of network-related items,
see the next item, "To change network settings."
115
8-4 Maintenance Menu