Using Umid Data - Sony PDW-1500 Operation Manual

S2202, switch 4
3
Replace the cover.
Note
Tighten the screws firmly.
To enable extended menu display in the
maintenance menu
Carry out the following operations.
SG DATA SG DATA SG DATA
ACCESS
ANA SDI ANA SDI ANA SDI
AE8/EBU AE8/EBU AE8/EBU
dB OVER dB OVER dB OVER
0 0 0
NETWORK -12 -12 -12
LOCAL -20 -20 -20
REMOTE
-30 -30 -30
-40 -40 -40
MONITOR
-60 -60 -60
15 26 37
CH- CH- CH-
L
MIX
R AUDIO
MONITOR SEL METER SEL INPUT CH
ALL/CH-1
VARIABLE
REC
PRESET
PB
PHONES
PREV PLAY
TOP F REV F FWD
1
Press the MENU button.

8-3-3 Using UMID Data

To perform operations from interviewing to editing
effectively and to detect audio-visual materials easily
when reusing them, metadata that provides additional
What is a UMID?
The UMID (Unique Material Identifier) is a unique
identifier for audio-visual material defined by the
SMPTE330M-2003 standard.
The UMID may be used either as the 32-byte Basic UMID
or as the Extended UMID, which includes an additional 32
bytes of Source Pack to make a total 64 bytes.
For details, refer to SMPTE 330M.
110
8-3 Extended Menu
1 8
EJECT
SG DATA EDIT REMOTE [9P iLINK] KEY INH
ALARM
ANA SDI INPUT
VITC VIUB COUNTER VITC REC INH
AE8/EBU
i.LINK
dB OVER
0 SDI
CMPST
-12 Y-R,B
SG
-20
HOURS MINUTES SECONDS FRAMES
-30
-40 MONITOR
-60 1/2 3/4 AUDIO 625 IMX[50 40 30]
48 5/6 7/8 4 8 CH 18 24 BIT 525 DVCAM
CH-
VIDEO COUNTER SYS MENU SHIFT
INPUT SEL INPUT SEL SELECT HOLD MENU
CH-2 CH-3 CH-4 SUB THUMB
CLIP NAIL SET RESET
CLIP ESSENCE S.SEL
MENU MARK MARK1
NEXT
STOP REC
IN OUT
END
MARK2
2 3,5,7 4,6
The menu appears in the time data display.
2
Hold down the COUNTER SELECT button, and press
the SET button.
In the time data display, first "MAINTE MENU"
appears momentarily, and then the item group name
appears.
3
Using the F/f buttons, display "Setup" in the time
data display.
4
Press the g button.
5
Using the F/f buttons, display "> Extended" in the
time data display.
6
Press the g button.
The time data display shows the current setting (">>
DISABLE").
7
Press the f button, to display ">> ENABLE" in the
time data display.
8
Press the SET button.
When you next display the menu and change the item
display, the extended menu will appear after the basic
menu.
information is recorded along with audio-visual data. As
one of application of metadata, the UMID (Unique
Material Identifier) is internationally standardized.