Pontiac Montana SV6 2008 Owner's Manual page 12

3. Slide the seat all the way back in this position.
To return the seat to the original position, do the
following:
1. Align the seat so that the rear hooks on the seat
are over the rear floor pins. Push down firmly on
the rear of the seat so that the rear hooks attach to
the rear floor pins.
1-8
4. Release the rear set of
seat hooks from the
floor pins by pulling the
nylon strap, located at
the base of the seat.
Use the strap to guide
the seat forward.
2. Try to raise the seat to check that it is locked to
the floor.
3. Pull the nylon strap, located on the rear right hand
side of the seat, or lift the recline lever, located
on the front right hand side of the seatback,
to raise the seatback to the upright position.
CAUTION:
{
If the seatback is not locked, it could move
forward in a sudden stop or crash. That could
cause injury to the person sitting there. Always
push and pull on the seatback to be sure it is
locked.
4. Push and pull on the seatback to check that it is
locked.