Pontiac Montana SV6 2008 Owner's Manual page 103

Passenger PSD
Activation Switch
If you have a single PSD, this switch is located in
front of the passenger side sliding door. If your vehicle
has dual PSDs, the switches are located in front of
both sliding doors.
Power Sliding Door Operation
The power sliding door(s) will only open if the transaxle
is in PARK (P). The transaxle does not have to be in
PARK (P) to close the door(s).
Your vehicle also has
passenger power sliding
door activation switch(es).
There are several ways to open and close the power
sliding door(s).
•
If your vehicle has a single power sliding door,
press the top of the overhead console PSD
activation/override (deactivation) switch.
•
If your vehicle has dual power sliding doors, press
the top of the driver's side and/or passenger's side
overhead console PSD activation/override
(deactivation) switch.
•
Press the passenger PSD activation switch. This
switch will also stop a moving door immediately.
•
Press the power sliding door button on the remote
keyless entry transmitter.
•
To manually open the power sliding door(s) while
the switch(es) are in the activation position, pull
and release the inside or outside door handle
to release the door latch. The door will fully open.
•
To manually close the power sliding door(s) while
the switches are in the activation position, pull
the inside or outside door handle or the edge of
the door. Move the door about 4 inches (10 cm)
toward the closed position and release it.
The door will close completely and latch.
2-17