Wps - Sapido GR-1733 User Manual

Mode
LAN IP Address
Security
DHCP
MAC Address
Note 1: LAN IP address should be under the same segment but cannot be the same number.
6.2.3

WPS

This page allows user to change the setting for WPS (Wi-Fi Protected Setup). Using this
feature could let your wireless client atomically synchronize it's setting and connect to the
Access Point in a minute without any hassle. SAPIDO GR-1733 could support both
Self-PIN or PBC modes, or use the WPS button (at real panel) to easy enable the WPS
function.
PIN model, in which a PIN has to be taken either from a sticker label or from the web
interface of the WPS device. This PIN will then be entered in the AP or client WPS device to
connect.
PBC model, in which the user simply has to push a button, either an actual or a virtual one,
on both WPS devices to connect.
Please follow instructions below to enable the WPS function.
1. Setup Wireless LAN with WPS PIN :
(1). Get the WPS PIN number from wireless card and write it down.
(2). Fill in the PIN number from the wireless card in Client PIN Number field, and then
click "Start PIN".
http://www.sapido.com.tw/
Router A
Router
Set the same segment as the
router B(Note 1)
Example :192.168.1.1
Set the same security as
Router B
Enable
Same as Router B
63
Router B
AP
Set the same segment as the
router A(Note 1)
Example :192.168.1.2
Set the same security as
Router A
Disable
Same as Router A
User Manual v1.0.0