Removing And Installing The Chassis On Support Rails - IBM F10 Service Manual

Figure 37. Disconnecting Interface Cables
3. Remove the controller module chassis (Figure 38).
Figure 38. Removing and Installing the Chassis on Support Rails
4. Service, move, or ship the controller module by choosing one of the following:
82
IBM 2102 Model F10 and Model D00 Service Guide
Remove the four screws (two in front, two in back) that secure the controller
module to the side rails. From the front of the cabinet, pull the chassis out of the
cabinet. Set it on a level, dry surface.
v If you are performing a service procedure, return to the appropriate page
and complete the instructions. When you are finished servicing the controller
module, you can reinstall it into the cabinet by reversing the steps in this
procedure.
v If you are moving the controller module to another rackmount cabinet,
remove the support rails and power cords from the old cabinet and install
them in the new one. Then, install the controller module by reversing the
steps in this procedure. Refer to "Chapter 2. Installation And Removal Guide"
on page 35 for instructions on installing the controller module.