Zte MF10 User Manual page 21

MF10 3G Wireless Router User Manual
BSSID: Show the MAC address of the Wi-Fi.
•
Frequency(Channel): The frequency band in which the WLAN operates. If some channels in your area
•
may have interference from other electronic devices, please choose the clearest channel to optimize the
performance and coverage of your wireless network. The default value is 2437MHz (Channel 6).
WDS Mode: WDS provides the radio monitoring and management communication. Lazy Mode, Bridge
•
Mode and Repeater Mode are available. The default value is Disable.
The HT physical Mode (Only available for 802.11n mode） parameters are shown in the following figure:
Operating Mode: Set the HT physical operating mode.
•
Channel BandWidth: Set the HT physical channel bandwidth.
•
Guard Interval: Set the HT physical guard interval.
•
MCS: Set fix MCS rate for HT rate.
•
Reverse Direction Grant(RDG):Enable RDG or not.
•
Extension Channel: Set extension channel. The extension channel is also able to send and receive data.
•
Aggregation MSDU(A-MSDU) : Mark to enable Hyper Throughput TX Aggregate MAC Service Data
•
Unit, and clear by selecting Disable.
Auto Block ACK: Block ACK(Acknowledge Number) or not during data transferring.
•
Decline BA Request: Reject peer BA-Request or not.
•
Click Apply to confirm your configuration.
Advanced
Select Wi-Fi Setting > Advanced, the advanced wireless network parameters and Wi-Fi multimedia
parameters are shown in the following figure:
Confidential and Proprietary Information of ZTE CORPORATION 21