Appendix A: Troubleshooting And Service; Appendix B: Specifications - Mackie MDR 24/96 Operation Manual

Appendix A: Troubleshooting and Service

Additional information and troubleshooting tips can be found in the HDR24/96
Technical Reference Guide. Technical support is available by contacting your
Mackie dealer, calling Mackie Designs at (800) 258-6883 (8:00 AM to 5:00 PM
Pacific Time), or visiting Mackie's website at www.mackie.com.
Please read the included warranty information, then complete and return the
included Warranty Registration card. You can also register online at www.mackie.com.

Appendix B: Specifications

Physical
Dimensions:
Shipping Weight:
Rack Space Height:
Electrical
Operating Voltage:
Power Consumption: 50W, max.
Motherboard/CPU
CPU:
Internal RAM:
CPU I/O
Networking:
MIDI:
Accessory Slots:
Hard Drive
Drive Size:
Recording Capacity:
Supported Drive Sizes: Up to 32 GB
Analog (with AIO•8 cards)
Frequency Response: < ± 0.25 dB, 5 Hz – 22 kHz.
Dynamic Range:
Conversion:
Reference Level:
I/O Options
AIO•8 Analog
DIO•8 TDIF & ADAT Optical
OPT•8 ADAT optical
OPT•24 ADAT optical
PDI•8 AES/EBU (w/ input sample rate conversion)
Synchronization
Time Code Frame Rates: 24, 25, 29.97, 29.97 Drop, 30, 30 Drop
Time Code Formats:
SMPTE Levels:
Sample Rates:
External Clock Rates:
Word Clock Input:
Word Clock Output:
56
MDR 24/96
7" x 19" x 13.25" (17.8 cm x 48.3 cm x 33.7 cm)
35.1 lb. (15.9 kg)
4 RU (Rack Units)
100/120 Vac & 220/240 Vac, 50/60Hz
Intel Celeron 433 MHz w/ 128k internal L2 cache
128 MB SDRAM
100 Base-T Ethernet, CAT-5 w/ RJ-45
MIDI In/Out, 5-pin DIN through 15-pin D-sub adapter
PCI (x2) for future expansion
20.4 MB UDMA IDE Standard
Greater than 90 minutes @ 24 tracks / 24-bit / 48kHz
(Internal & Mackie Media M•90)
101 dB
24-bit, 128x oversampling
0 dBFS = +22 dBm
SMPTE In or SMPTE Out on 1/4" TRS jack
MTC In and Out on DB9 MIDI connector
+4 dBu, –10 dBV (default), software selectable
44.1 kHz / 48 kHz / 96 kHz (w/ PDI•8 card)
43.6 kHz to 50.6 kHz @ 48 kHz setting
40.1 kHz to 48.9 kHz @ 44.1 kHz setting
TTL, 2-5 Vp-p, 75 Ohms terminated, 3.3k Ohms (bridging)
CMOS, 0-5 Vp-p, <30 Ohms