Mackie MDR 24/96 Operation Manual page 24

2. Connect three snakes to the MDR24/96 Outputs (top connector). Connect
MDR24/96 Settings
1. Set the Sample Clock to Internal.
2. Set the Sample Rate and Bit Depth according to your preference.
Console Settings
Set the 24•8 console to the nominal +4 dBu operating level by setting the
five Operating Level switches in the Sub Out and Tape Return sections to
the 'OUT' position.
This example describes the hookup for the D8B console equipped for analog I/O.
AIO•8 Cards
Note: Note: Note: Note: Note: Some older
AIO•8 cards have
the Input jack la-
beled as "From
Tape" and the Out-
put jack labeled as
"To Tape." Other-
wise, they operate
Cables & Hardware
identically. Sigh ...
long story.
Hookup
1. Connect three snakes between the MDR24/96 Inputs (bottom connector)
2. Connect three snakes between the MDR24/96 Outputs (top connector)
MDR24/96 Settings
1. Set the Sample Clock to Internal.
2. Set the Sample Rate and Bit Depth according to your preference. It is not
Console Settings
1. Set the D8B Sample Clock to 44.1 k Internal or 48 k Internal according
24
MDR 24/96
the plug end of the snakes to the like-numbered Tape Return jacks on the
24•8 console.
MDR 24/96
ANALOG I/O ANALOG I/O ANALOG I/O
TAPE IN/OUTS
(3) AIO•8 cards for MDR24/96
(3) AIO•8 cards for D8B
(6) DB25 to DB25 analog snakes
and the corresponding D8B Tape Outputs (top connector).
and the corresponding D8B Tape Inputs (bottom connector).
necessary to set the D8B and MDR24/96 to the same sample rate since,
with analog connections, the sample clocks on the two units are not
synchronized.
to your preference.
Digital 8•Bus
(6) DB25 to
ANALOG I/O ANALOG I/O ANALOG I/O
DB25 Analog
Snakes
TAPE IN/OUTS
AIO•8 Cards