Net Partition (Combi) - Skoda Fabia Owner's Manual

Removing and installing carrier rails
Fig. 52 Slacken check points/remove carrier rails
Removing
›
Slacken the check points » Fig. 52
B
a flat screwdriver.
›
Grasp the carrier rail at position
A
of arrow. You can take out the removable storage compartments in order to fa-
cilitate the removal » page 68, Storage compartments in the boot.
›
Grasp the carrier rail at position
A
of arrow.
›
The carrier rail on the other side of the luggage compartment can be removed
in the same way.
Install
›
Position the carrier rails on the sides of the boot.
›
Press both check points on each carrier rail
›
Check the attachment of the carrier rails by pulling it.
WARNING
Ensure that the carrier rails and variable loading floor are correctly fastened
when installing the variable loading floor. If this is not the case, there is a risk
of injury for the occupants.
58
Using the system
on the carrier rails using the vehicle key or
and slacken it by pulling in the direction
1
and slacken it by pulling in the direction
2
B » Fig. 52 up to the stop.

Net partition (Combi)

ä
Introduction
This chapter contains information on the following subjects:
Using the net partition behind the rear seats
Using the net partition behind the front seats
Removing and installing net partition housing
WARNING
The belt locks and the belts must be in their original position after folding
■
back the seat cushions and backrests - they must be ready to use.
The seat backrests must be securely interlocked in position so that no ob-
■
jects in the luggage compartment can slide into the passenger compartment if
there is sudden braking - risk of injury!
Ensure that the rear seat backrests are properly engaged. It is only then that
■
the three-point seat belt for the middle seat can reliably fulfil its function.
Ensure that the cross rod is inserted into the mounts
■
page 59 or » Fig. 54 on page 59 in the front position!
Ð
59
59
60
» Fig. 53 on
C
Ð