Rear Seats - Skoda Fabia Owner's Manual

Rear seats

Folding the seat backrest forwards
The luggage compartment can be increased in size by folding the seat backrests
forward. The seat backrests can be folded forward individually on vehicles with
divided rear seats.
Folding forward
›
Before folding the rear seats forwards, adapt the position of the front seats in
such a way that they are not damaged by the folded rear seats.
›
Unlock the seat backrest by pressing the securing knob
forwards.
›
Pull the head restraint out of the seat backrest.
›
Fold the seat backrest completely forwards.
Folding backwards
›
Push the head restraint into the slightly lifted seat backrest.
›
Then push the seat backrest back into the upright position until the securing
knob clicks into place - check by pulling on the seat backrest
›
Make sure that the red pin is hidden.
B
WARNING
The belts and the belt locks must be in their original position after folding
■
back the seat backrests - they must be ready to use.
The seat backrests must be securely interlocked in position so that no ob-
■
jects in the boot can slide into the passenger compartment if there is sudden
braking - risk of injury.
Ensure that the rear seat backrests are properly engaged. It is only then that
■
the three-point seat belt for the middle seat can reliably fulfil its function.
52
Using the system
Fig. 41
Unlock the seat backrest
» Fig. 41 and fold it
A
» .
CAUTION
Ensure that the seat belts are not damaged when operating the seat backrests.
Under no circumstances must the rear seat belts be jammed by the folded back
seat backrests.
Note
On vehicles with an installed net partition housing, first fold back the left seat
rest followed by the right one.
Folding the seat cushions forwards, removing
Fig. 42 Folding the seat cushions forwards and removing
The luggage compartment can be increased in size by folding the seat backrests
forward or by removing the rear seats.
Folding forward
›
Pull up the seat cushion in the direction of the arrow
wards in the direction of the arrow
Removing
›
Fold the seat cushion forward.
›
Press the wire clamps in the direction of the arrow
seat cushion from its holder.
Install
›
Press the wire clamp in the direction of the arrow
the holder.
›
Fold the seat cushion back into its original position.
» Fig. 42 and fold for-
1
.
2
» Fig. 42 -  and remove the
» Fig. 42 -  and put it into
Ð
Ð