Detroit Diesel 60 Operator's Manual page 95

diesel fuel and coat the gaskets
lightly with the fuel oil.
6. Thread the new filters onto the
adaptor inserts until the gaskets
make full contact with the adaptor
head and no side movement is
evident.
NOTICE:
Overtightening the filter may crack
or distort the adaptors.
7. Tighten filters an additional
one-half turn by hand, or as
indicated on the filter.
8. Turn the handle on the shutoff
valve to the Open position (in
line with the valve).
All information subject to change without notice.
DDC-SVC-MAN-0039
SERIES 60 ON-HIGHWAY ENGINE OPERATOR'S GUIDE
Copyright © 2009 DETROIT DIESEL CORPORATION
PERSONAL INJURY
Diesel engine exhaust and some
of its constituents are known to
the State of California to cause
cancer, birth defects, and other
reproductive harm.
□ Always start and operate an
engine in a well ventilated
area.
□ If operating an engine in
an enclosed area, vent the
exhaust to the outside.
□ Do not modify or tamper
with the exhaust system or
emission control system.
9. Start the engine and check for
leaks. Shut down the engine.
Correct any leaks with the engine
off.
If the engine fails to start after filter
replacement, the fuel system will
require priming with tool J 5956 (or
equivalent). Authorized Detroit Diesel
distributors are properly equipped to
perform this service.
83