Filling Fuel Tank - Ariens 924119 Owner's/Operator's Manual

Electric Starter
The Electric Starter will start a properly choked and
cranked engine when the key is turned (12V) or start
button (120V) is pushed. Refer to Starting and
Shut-Off.
Recoil Starter Handle
When pulled, handle will turn engine over.
Discharge Chute Deflector
ALWAYS position Discharge Chute Deflector at safe
angle before starting engine.
Push Deflector handle forward or down to throw snow
lower. Pull Deflector Handle up or to the rear to throw
snow higher.
IMPORTANT: If Chute Deflector does not stay in set
position, adjust as directed in Service and
Adjustments, or repair before operation.
Deflector Remote (119,502,503)
Place Deflector into position before operation. DO NOT
throw snow any higher than necessary.
Push Deflector Remote forward to throw snow lower.
Pull Deflector Remote back to throw snow higher.
Discharge Chute
Discharge Chute rotates 220°.
ALWAYS position discharge chute straight ahead while
starting unit.
Chute Crank Handle (119,120,330,334)
Rotate the Chute with Discharge Chute Crank Handle.
IMPORTANT: DO NOT force frozen Chute controls.
Start engine and run for 3-5 minutes to thaw. If still
frozen, take to warm place until controls are free.
Chute Rotation Switch (502,503)
2
1
OS1970
Heated Handles
Turn the heated handles switch to the
1
ON (1) position to activate. Turn the
switch to the OFF (2) position to
deactivate.
2
OS1950
Press the chute rotation
switch right (1) to rotate
chute clockwise. Press the
chute rotation switch left
(2) to rotate chute
counterclockwise.
Differential Lock (120,333,334,502,503)
Differential Lock knob is located on the Left
1
Wheel Hub. With differential locked power is
applied equally to both wheels.
To engage differential lock:
2
• Pull and turn knob to LOCKED (1)
position and release (knob will snap in
place when positioned correctly).
OL2730
To resume differential action for transport:
• Pull and turn knob to UNLOCKED (2) position
and release.
Axle Lock Pin (119)
The axle lock pin is located on the right wheel hub.
Moving pin from the hub to the axle shaft allows the
right wheel to turn freely.
Scraper Blade
The scraper blade allows the back of the housing to
keep better contact with the surface being cleared. It
also prevents damage to the housing from normal
wear.
IMPORTANT: DO NOT allow Scraper Blade to wear
too far or Auger/Impeller housing will become
damaged.
Runners
For operation on gravel surface, lower Runners so that
housing will not pick up gravel. On concrete, blacktop
or packed snow surfaces raise Runners so that
Scraper Blade scrapes clean.
Headlight
NOTE: Lamp remains on at all times for longer lamp
life. Lamp is more sensitive to fatigue when unlit.

FILLING FUEL TANK

WARNING: FLAMMABLE FUEL and its
EXPLOSIVE VAPORS can result in death or
serious injury.
Handle fuel with extreme care. ALWAYS use
an approved fuel container.
No Smoking! No Lighted Materials!
No Open Flames!
Allow engine to cool before any service.
To add fuel to Fuel Tank:
1. ALWAYS place unit in open or well ventilated
area.
2. Stop engine and allow to cool.
3. Clean Fuel Cap and surrounding area to prevent
dirt from entering Fuel Tank.
4. Remove Cap.
GB - 12