Purging The Brewer; Brewing Hot Water - Keurig Select B77 Owner's Manual

The Water Reservoir can be filled in two ways.
9
fig.
Lift off the Water Reservoir Lid and pour
1.
water directly into the Water Reservoir
while it is still attached to the Brewer,
NOT READY then replace the Lid.
ADD
2. Remove the Water Reservoir from Brewer by
WATER
first removing Lid from the Water Reservoir, then
MENU
lifting the Water Reservoir straight up and toward
front of Brewer. Fill with water. Place the Water
MENU
Reservoir back on the Brewer and replace the Lid.
IMPORTANT: Do not remove the Water Reservoir
BREW
during the brewing process.

Brewing Hot Water

Your Brewer is able to produce hot water for making hot cocoa from a packet,
for use in cooking, for making soups, etc. Simply follow the instructions on
page 7 — "Ready To Brew Your First Cup" without adding a K-Cup.
NOTE: After brewing a hot cocoa K-Cup, we recommend running a hot water
brew cycle without a K-Cup.

Purging the Brewer

If your Brewer has not been used for more than one week, you should purge
the water from the inner tank.
If there is water in the Water Reservoir, remove the Lid, then lift the
1.
Water Reservoir straight up and away from Brewer. Discard water, rinse
and refill with water. Place the Water Reservoir back on the Brewer and
replace the Lid. (If there is no water in the Water Reservoir, simply refill.)
Be sure the Brewer is turned on. Raise and lower the Handle on the
2.
Brewer without inserting a K-Cup.
The LCD Control Center will display "READY TO BREW." Brew a Large
3.
Mug (9.25 oz. serving) of water (do not use a K-Cup).
4. Repeat steps 2 and 3 two more times to completely purge water from
inner tank.
If you are experiencing any problems with your Brewer, please contact
Customer Service at 1.866.901.BREW (2739).
9