Cleaning External Parts; Cleaning/Maintenance - Keurig Select B77 Owner's Manual

SECTION 3

cleaning External Parts

Regular cleaning of the Brewer's external components is recommended.
1. Never immerse the Brewer in water or other liquids. The Housing
and other external components may be cleaned with a soapy, damp,
non-abrasive cloth.
The Drip Tray can accumulate up to 12 ounces of overflow. The Drip Tray
2.
and Drip Tray Plate should be periodically inspected and rinsed clean.
To remove the Drip Tray Assembly, simply slide it toward you, keeping it
level at all times to avoid spilling. The Drip Tray and Drip Tray Plate are
dishwasher safe.
cleaning the K-cup Holder assembly
17
1. Cleaning the Parts —
fig.
Assembly can be placed onto the top shelf of
a dishwasher.
cycles in the dishwasher.
Brewer, open the Lid by lifting the Handle.
Grasp the top of the K-Cup Holder with one
hand while pushing up on the bottom of the
K-Cup
other until it releases (fig. 17). After cleaning,
align the K-Cup Holder with the opening using
the two front ribs as a guide, and snap into
place from the top.
Cleaning & Maintenance
The K-Cup Holder
NOTE: Use low temperature
To remove from the
Holder from underneath with the
®
18
fig.
!
CAUTION: There are sharp needles that puncture the K-Cup above the K-Cup
Holder and in the bottom of the K-Cup Holder. To avoid risk of injury, do not
put your fingers in the K-Cup Assembly Housing.
cleaning the Water Reservoir & Water Reservoir Lid
The Water Reservoir Lid or Water Reservoir should not be put into the
dishwasher. They should be cleaned with a damp, soapy, non-abrasive cloth
and rinsed thoroughly. Do not dry the inside of the Water Reservoir with a
cloth as lint may remain.
CAUTION: Please rinse the Water Reservoir thoroughly after cleaning to ensure
that no cleaners or cleaning solutions remain in this area as they may contaminate
the water supply in the Brewer.
13
The Funnel can be
2. Cleaning the Funnel —
removed from the K-Cup Holder by pulling
®
on it until it pops off (fig. 18). The Funnel is
dishwasher safe. To replace it, just snap it
back onto the K-Cup Holder Assembly.
The Exit Needle is
3. Cleaning the Exit Needle —
located on the inside bottom of the K-Cup
Holder Assembly. Should a clog arise due to
coffee grinds, it can be cleaned using a paper
clip or similar tool. Remove K-Cup Holder
assembly and detach Funnel. Insert the paper
clip (as shown in fig. 18) into the Needle to
loosen the clog and push it out. The K-Cup
Holder is dishwasher safe.