Installing The Motor Housing; Assembling The Blades - Hunter 42819-01 Installation And Operation Manual

5 • Installing the Motor Housing
Step 5-1 5-1. Place the fan housing over the motor.
5-2. Align the keyholes in the fan housing with the two partially
Motor
Fan Housing
5-3. Install the two remaining canopy screws into the holes in the fan
Step 5-3
8
Canopy
Screw
Hunter Fan Company
installed canopy screws in the hanger bracket. Rotate the fan
housing to situate the screws in the narrow ends of the keyholes.
housing and into the hanger bracket. Securely tighten all screws.
42819-01 • 11/14/06
Hunter fans use several styles of fan blade irons (brackets that hold the
blade to the fan).
6-1. Your fan may include blade grommets. If your fan has grommets,
insert them by hand into the holes on the blades.
6-2. Attach each blade to a blade iron using three blade assembly
screws. If you used grommets, the blades may appear slightly loose
after screws are tightened. Th is is normal.
6-3. Some blade mounting screws are installed in the motor to
secure shipping blocks. Remove the blade mounting screws and
rubber bumpers from the motor. Save the screws and discard the
bumpers.
6-4. For each blade, insert one blade mounting screw through the
blade iron, and attach lightly to the fan. Insert the second blade
mounting screw, then securely tighten both mounting screws.
Blade Assembly
Screws
Use with grommet
Use without grommet
Blade
Mounting
Screw
42819-01 • 11/14/06
6 • Assembling the Blades
Step 6-1 (Detail)
Grommet
Steps 6-1 – 6-2
Step 6-4
Hunter Fan Company
9