Assembling And Hanging The Fan - Hunter 41923 Installating And Operation Manual

3 • Assembling and Hanging the Fan
Steps 3-1 – 3-2
Adapter
Steps 3-4 – 3-5
Low Profile Washer
6
#8-32 x 3/4" Screw
Hunter Fan Company
You can assemble your fan for standard mounting (steps 3-1 – 3-2)
or for low profile mounting (steps 3-3 – 3-5). Note: For low profile
mounting, the downrod is replaced with the low profile washer.
Downrod
3-1. To assemble fan to hang down from a flat or angled ceiling, insert
the downrod through the canopy and canopy trim ring. Feed the
Canopy
wires from the fan through the downrod.
3-2. Using the provided allen wrench, loosen the allen head set screw
Canopy
on the adapter to install the pipe and ball assembly. Note: When
Trim Ring
the pipe and ball assembly is fully installed, 2-3 threads on the
Allen Head
pipe will still be visible; this is normal. Securely retighten the set
Set Screw
screw with the allen wrench. Skip to Step 3-6.
CAUTION: e adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
3-3. Remove the set screw from the adapter.
3-4. To assemble the fan to hang from a low ceiling, place the low
profile washer (lip up) into the canopy. Be sure the green ground
wire is pointing up toward the ceiling.
3-5. Align the holes in the washer with the holes in the adapter.
Assemble securely with three #8-32 x 3/4" screws.
3-6. Raise the fan and place the hook on the ceiling plate through the
U-shaped hole in the rim.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Step 3-6
U-shaped
Hole
41923-01 • 11/21/05