Cisco ASR 9000 Series Configuration Manual page 206

RADIUS Disconnect-Cause Attributes
Cause Code
600
601
602
603
604
605
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide,
Release 4.2.x
196
Value
VPN-User-Disconnect
VPN-Carrier-Loss
VPN-No-Resources
VPN-Bad-Control-Packet
VPN-Admin-Disconnect
VPN-Tunnel-Shut
RADIUS Attributes
Description
Call disconnected by client
(through PPP).
Code is sent if the LNS receives a
PPP terminate request from the
client.
Loss of carrier. This can be the
result of a physical line going dead.
Code is sent when a client is unable
to dial out using a dialer.
No resources available to handle
the call.
Code is sent when the client is
unable to allocate memory (running
low on memory).
Bad L2TP or L2F control packets.
This code is sent when an invalid
control packet, such as missing
mandatory Attribute-Value pairs
(AVP), from the peer is received.
When using L2TP, the code will
be sent after six retransmits; when
using L2F, the number of
retransmits is user configurable.
VPN-Tunnel-Shut will be
Note
sent if there are active
sessions in the tunnel.
Administrative disconnect. This
can be the result of a VPN soft
shutdown, which is when a client
reaches maximum session limit or
exceeds maximum hopcount.
Code is sent when a tunnel is
brought down by issuing the clear
vpdn tunnel command.
Tunnel teardown or tunnel setup
has failed.
Code is sent when there are active
sessions in a tunnel and the tunnel
goes down.
This code is not sent when
Note
tunnel authentication fails.
OL-26148-02