Configuring Route-Policy For Unicast Qos Shaper - Cisco ASR 9000 Series Configuration Manual

Configuring Subscriber Features
Command or Action
Step 5
unicast-qos-adjust holdoff time
Example:
RP/0/RSP0/CPU0:router(config-igmp)#
unicast-qos-adjust holdoff 5
Step 6 vrf vrf-name
Example:
RP/0/RSP0/CPU0:router(config-igmp)# vrf
vrf1
Step 7 traffic profile profile-name
Example:
RP/0/RSP0/CPU0:router(config-igmp-vrf1)#
traffic profile routepolicy1
Step 8 Use the commit or end command.
Configuring the IGMP QoS Shaper: An Example
configure
router igmp
unicast-qos-adjust adjustment-delay 1
unicast-qos-adjust download-interval 10
unicast-qos-adjust holdoff 5
vrf vrf1
traffic profile routepolicy1
!
!
end

Configuring route-policy for Unicast QoS Shaper

Perform this task to configure route-policy for unicast QoS shaper.
OL-26148-02
Cisco ASR 9000 Series Aggregation Services Router Broadband Network Gateway Configuration Guide, Release
IGMP to Unicast QoS Shaper Correlation
Purpose
Configures the hold-off time before QoS clears the stale entries
for the IGMP QoS shaper. The hold-off time ranges from 5 to
1800 seconds.
Enters the VRF configuration mode.
Configures the route-policy to be used to map the bandwidth
profile.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
4.2.x
147