Tube Channel Replacement - Quadra-Fire 4300 Series Owner's Manual

R
F. Tube Channel Assembly Replacement
Removing Tube Channel Assembly
1. Remove the right side shield by removing 2 screws in the
back using a Phillips head screw driver.
2. Remove 4 screws from channel access cover and remove
cover.
3. Locate 2 channel nuts inside of chamber and remove
using a 7/16 socket wrench. Slide out tube channel
assembly.
NOTE: Soak the bolts with penetrating oil for at least 15 min-
utes before trying to remove them.
Replacing Tube Channel Assembly
1. Silde one gasket on each tube fi rst.
2. Slide the tube channel assembly into side of fi rebox and
insert each tube into the corresponding hole in the tube
channel rack starting with the back hole fi rst.
3. Make sure tube channel assembly is fl ush against the
side of the stove and secure with channel nuts.
4. Re-install channel cover and side shield.
Tube Channel Rack
Figure 37.1
August 31, 2010
In order to replace the tube channel assembly a clearance
of 19 inches (483mm) is required on the right side of stove
in order to remove the tubes with the stove in place.
If space is not available, the stove will have to be discon-
nected from the chimney to proceed with the tube replace-
ment.
Slide one gasket
over each tube
Channel
Access
Cover
Tube Channel
Assembly
7037-135G
4300 Wood Stove Series (ACC)
NOTE: Service Space
Channel Cover
Screws (4)
Remove
2 Screws
Channel
Nuts (2)
Side Panel
Page 37