Information About Selected Parameters; System Information Page; Figure 18: System Information Page (Top Part) - Hughes HN9000 User Manual

System Control Center

Information about selected parameters

This section provides information for selected parameters on the Terminal Status page. Parameters that may be most
useful for you to know about are listed.
The Dial Backup Status parameter and Dial Backup Status category of parameters do not apply to the HN9000 satellite
modem.

System Information page

The System Information page shown in Figure 17: Terminal Status page (top part) on page 19 provides system
information for the satellite modem such as ST name (modem name), Site ID (Site Id), and operational software version.
Note: Print the System Information page and save it. Click Print this page next to the printer icon. If you experience
a problem with your satellite modem this page may not be accessible. Information on this screen may be useful to
a Hughes Customer Care representative in helping you to resolve the problem.
The operational parameters listed on the System Information page are shown in a tabular format. The first (left) column
identifies the parameter categories:
• Identification – Contains system ID information such as Site ID (installation site ID) and ST name (a unique name
that identifies the satellite modem).
• Software – Contains version information on the various software applications resident on the satellite modem such
as commissioning and operational software. (Commissioning refers to initial start-up of the modem.)
• Satellite – Contains information pertaining to communication with the satellite such as antenna size, transmit radio
wattage, and uplink transmission mode.
HN9000 Satellite Modem User Guide –
1037577-0001 Rev. A

Figure 18: System Information page (top part)

Chapter 2
19