Hitron CGN User Manual page 40

Table 9: The Status > CM Status Screen (continued)
Downstream Frequency
Upstream ID
Downstream
NOTE: The downstream signal is the signal transmitted to the CGN.
Frequency (MHz)
Modulation
Signal Power (dBmV) This displays the power of the signal of each
Signal Noise Ratio
(dB)
Upstream
NOTE: The upstream signal is the signal transmitted from the CGN.
Frequency (Hz)
Bandwidth (KSym/
sec)
40 40
HITRON CGN USER'S GUIDE
This displays the center frequency in Megahertz (MHz)
at which the CGN connects over the CABLE interface.
If you want the CGN to use a different center frequency,
enter it in the field and click Apply.
NOTE: Do not change the frequency unless you have a
good reason to do so.
This displays the ID number of the channel on which the
upstream signal is to be transmitted. When an upstram
connection cannot be made on the specified channel,
the CGN attempts to connect on the next channel.
If you want the CGN to attempt to connect on a different
channel, enter it in the field and click Apply.
NOTE: Do not change the channel unless you have a
good reason to do so.
This displays the actual frequency in Megahertz (MHz)
of each downstream data channel to which the CGN is
connected.
This displays the type of modulation that each
downstream channel uses.
downstream data channel to which the CGN is
connected, in dBmV (decibels above/below 1 millivolt).
This displays the Signal to Noise Ratio (SNR) of each
downstream data channel to which the CGN is
connected, in dB (decibels).
This displays the frequency in Herz (Hz) of each
upstream data channel to which the CGN is connected.
This displays the bandwidth of each upstream data
channel to which the CGN is connected (in thousands of
symbols per second).
Version 2.0, February 2012. Copyright
Version 2.0, February 2012. Copyright
2012 Hitron Technologies
2012 Hitron Technologies