Aerobics Silver Select XP Owner's Manual page 13

ASSEMBLY INSTRUCTIONS (cont'd)
Step Eleven:
Insert the cup holder (23) into the hole in the control panel (16). Push down until you hear and
feel it firmly snap in place.
Note: The cup holder should sit flush to the control panel when it is snapped in place. If not, remove
cup holder and rotate 180 degrees, then reinstall.
IMPORTANT:
Cup holder comes with a black foam pad to be
kept on the bottom of the cup holder. This will
help protect your cup holder from being scratched
and reduce noise.
DO NOT THROW AWAY.
Step Twelve:
To install the motor cover, stand in front of the treadmill. Pick up the motor cover (24) so
it is level. Holding the motor cover level and waist high, tilt it 45 degrees by lowering
your left hand. Then slide it between the handlebars and lower the motor cover until it is
level. Lower the cover all the way, keeping it level. Screw the two #8x1/2" black sheet
metal screws (25) into the front of the motor cover. Press down on each side of the
motor cover where it meets the silver plastic deck shrouds to lock the Velcro pads into
place.
CAUTION: Do not raise or lower motor cover without it being level.
24
25
13