Advertisement
TROUBLESHOOTING (cont'd)
CAUTION: Unplug your treadmill before attempting any cleaning, maintenance, or service.
Error Code 133 or 134
This is a communication error that could be a result of the black wire harness not being plugged in all the way. Unplug the treadmill from
the wall outlet and reconnect the black wire harness that you plugged in during Step Two of assembly, see page 6.
Error Code 149
Error code 149 indicates a button was pressed when the magnetic key was inserted into the control panel. Do not press down on any
button when inserting the magnetic key. Make sure any accessories that are mounted to the control panel (book rack, etc.) are not
making contact with the membrane.
uSA
Silr
Error Code 298
Error Code 298 is an RPM signal code - indicates a loss of the RPM signal during a workout. Check all wiring connections (optical sensor
and wiring harness) and all wiring for cuts or damage. (See Figure 2 page 6).
Error Code 307
Indicates that there was no speed sensor signal at start up. Check the speed sensor connection and wiring.
Error Code 425
After start is pressed, the tread belt does not move and then "Err 425" appears. To reset this error code you must unplug the treadmill from
the wall outlet for 10 seconds, and then check the items listed below.
Check the drive motor wire connection to the power supply.
Check the ceramic fuse (20 Amp – 250 V) on the power supply.
Elevation Error Codes
217
Err
"Err" in the Incline Display - indicates a problem with the elevation system. Note: The treadmill will still function with the "Err" displayed
in the incline Display, but the elevation system will not function. To determine the exact error code follow the procedure below.
Insert the magnetic key, For the purpose of this test, DO NOT stand on the tread belt
If "Err" appears in the incline display after pressing the Start/Quick, Stop/Reset, or Pause/Enter button, the control panel is not receiving an
elevation reading. Start the treadmill, then press the Up or Down Incline button, an "E 219" will appear in the Results Display. Check the
both wiring connections between the elevation motor and the power supply. Also, check the wiring harness for cuts or visual damage.
If "Err" appears in the incline display after attempting an elevation change, the control panel did not see elevation movement. Touch the
incline Up or Down button and an "E 217" will appear in the Data Window. Check the wiring connection between the elevation motor and
the power supply. Check the elevation fuse to see if it has blown. If the fuse has blown, replace fuse.
37
Hide quick links:
Advertisement
