Fcc Notice; Important Note On The Interface Connectors - Kyocera Ecosys FS-6700 Service Manual

FCC notice

This device complies with Part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential instal-
lation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harm-
ful interference to radio communication. However, there is no guarantee that inter-
ference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which
•
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
•
Change or modifications not expressly approved by the manufacturer for compli-
ance could void the userís authority to operate the equipment.
Interference cable to the computer shall be used with shielded circular cable.
Any modification without prior permission may cause harmful interface. If any
modification/change is introduced to this equipment without prior permission, Kyo-
cera, as the manufacturer, cannot guarantee compliance with FCC rules.
To use equipment which does not comply with FCC rules is prohibited. Conforming
to Class B limits, the printer may be optionally installed with the following units:
EF-1 Envelope Feeder
•
DU-25 Duplexer
•
PF-25 Paper Feeder
•
IB-3 AppleTalk Interface Board
•
PK-series KPDL Upgrade Kit
•

Important note on the interface connectors

Be sure to turn off printer power before connecting or disconnecting an interface
cable to the printer.
Warning This equipment has been certified to comply with the limits for a Class
B computing device, pursuant to Subpart J of Part 15 of FCC Rules.
Only peripherals (computer input/output devices, terminals, etc.) cer-
tified to comply with the Class B limits may be attached to this equip-
ment. Operation with non-certified peripherals is likely to result in
interference to radio and TV reception.
P R O D U C T
1-10
I N F O R M A T I O N
Safety information
FS-6700