Removing The Fuser Unit; Removing The Heater Lamp - Kyocera Ecosys FS-6700 Service Manual

Disassembly
Disassembly: Main unit printer

Removing the fuser unit

Remove the left and right covers (page 5-10,
Warning
Detach all connectors from the fuser unit first. Remove the four screws
the fuser unit from the printer.

Removing the heater lamp

Warning
Remove the two screws
FS-6700
The fuser is hot after the printer was running. Wait until it cools down.
The heater is extremely hot immediately after the printer was run-
ning. Allow substantial period of time until it cools down. Also, the
heater is fragile: Handle it with great care.
. Remove the cover from the fuser unit.
5-13
).
Removing covers
. Pull out