Planet WNRT-620 User Manual page 53

This is the LAN client/host IP address that the Public Port number packet will
be sent to.
Private IP
Note: You need to give your LAN PC clients a fixed/static IP address for
Virtual Server to work properly.
This is the port number (of the above Private IP host) that the below Public
Private Port Port number will be changed to when the packet enters your LAN (to the
LAN Server/Client IP).
Select the port number protocol type (TCP, UDP or Both). If you are unsure,
Type
then leave it to the default both protocols.
Enter the service (service/Internet application) port number from the Internet
that will be re-directed to the above Private IP address host in your LAN.
Public Port
Note: Virtual Server function will have priority over the DMZ function if there
is a conflict between the Virtual Server and the DMZ settings.
Fill in the "Private IP", "Private Port", "Type", "Public Port" and "Comment" of
the setting to be added and then click "Add". Then this Virtual Server setting
Add will be added into the "Current Virtual Server Table" below. If you find any
typo before adding it and want to retype again, just click "Clear" and the
fields will be cleared.
Reset Click "Reset" will clear your current settings to allows you to enter again.
Current Virtual Server Table
If you want to remove some items from the "Current Virtual Server Table",
Delete Selected select the MAC addresses you want to remove in the table and then click
"Delete Selected".
Delete All If you want remove all items of the table, just click this button.
Reset Click "Reset" will clear your current selections.
After configuration complete, please click "Apply" button to save the configuration. Then you will see a
screen to prompt you the settings are saving successfully. You may press "Continue" for configure other
settings or "Apply" to restart WNRT-620 with new configuration. Please refer to section 4.2.7 for more
information about this screen.
- 47 -