Table of Contents
Advertisement
Parameters
Description
"Fragment Threshold" specifies the maximum size of packet during the
Fragment Threshold
fragmentation of data to be transmitted. If you set this value too low, it will result
in bad performance.
When the packet size is smaller the RTS threshold, the access point will not use
RTS Threshold
the RTS/CTS mechanism to send this packet.
The interval of time that this access point broadcast a beacon. Beacon is used to
Beacon Interval
synchronize the wireless network.
Set the DTIM period of wireless radio. Do not modify default value if you don't
DTIM Period
know what it is, default value is 3.
The Data Rate is the rate of data transmission for 802.11b/g clients. The
Data Rate
WNRT-620 will use the highest possible selected transmission rate to transmit
the data packets.
Set the wireless data transfer rate to a certain value for 802.11n clients. Since
N Data Rate
most of wireless devices will negotiate with each other and pick a proper data
transfer rate automatically. Please refer to "N Data Rate Table" as below.
Set channel width of wireless radio. Do not modify default value if you don't know
Channel Width
what it is, default setting is 'Auto 20/40 MHz'.
Preamble type defines the length of CRC block in the frames during the wireless
Preamble Type
communication. "Short Preamble" is suitable for high traffic wireless network.
"Long Preamble" can provide more reliable communication.
If you enable "Broadcast ESSID", every wireless station located within the
coverage of this access point can discover this WNRT-620 easily. If you are
Broadcast ESSID
building a public wireless network, enabling this feature is recommended. In
private network, disabling "Broadcast ESSID" can provide better security.
It is recommended to enable the protection mechanism. This mechanism can
decrease the rate of data collision between 802.11b and 802.11g wireless
CTS Protection
stations. When the protection mode is enabled, the throughput of the AP will be a
little lower due to many of frame traffic should be transmitted.
Users can adjust the WNRT-620 output power to 100%, 90%, 75% 50% 25% and
TX Power
10%. In default, WNRT-620 will work with 100% output power.
Enable/Disable Turbo mode. When the connect client has support Turbo mode, it
Turbo Mode
will enhance the data transfer rate of LAN (up to 35Mbps, only for 11g).
The short of Wi-Fi Multi-Media, it will enhance the data transfer performance of
WMM
multimedia contents when they're being transferred over wireless network.
After configuration complete, please click "Apply" button to save the configuration. Then you will see a
screen to prompt you the settings are saving successfully. You may press "Continue" for configure other
- 32 -
Advertisement
Table of Contents
