Planet WNRT-625 User Manual page 68

Mode
Band
ESSID
Site Survey
WLAN MAC
After configuration complete, please click "Apply" button to save the configuration. Then you will see a
screen to prompt you the settings are saving successfully. You may press "Continue" for configure other
settings or "Apply" to restart WNRT-625 with new configuration. Please refer to section 4.2.7 for more
information about this screen.
Shows the current operation mode. You may set WRT-625 to other
operating mode by select other operating mode.
2.4GHz (B): It forces the WNRT-625 to operate in 802.11b only.
2.4GHz (G): It forces the WNRT-625 to operate in 802.11g only.
2.4GHz (N): It forces the WNRT-625 to operate in 802.11n only.
2.4GHz (B+G): It allows the WNRT-625 to operate in 802.11b and
802.11g simultaneously.
2.4GHz (B+G+N): It allows the WNRT-625 to operate in 802.11b,
802.11g, and 802.11n simultaneously.
Please make sure the ESSID of the wireless network that you will connect
and enter the correct ESSID in this field. The default value is "default".
You also can press "Select Site Survey" button to choose wireless
network that exists at the moment you will connect.
You may press "Refresh" to get the new Access Point and select one of
them to click "Done" to connect.
Keep default setting: WRT-625 will use it's own MAC address to access
the wireless LAN.
Press "MAC Clone" button: It will use PC's MAC address to access the
wireless LAN.
- 63 -