Planet WNRT-625 User Manual page 60

Parameters Description
Check "Enable MAC Filtering" to enable MAC Filtering.
If select "Deny", all PCs will be allowed to access Internet accept for the PCs
Enable MAC Filtering in the list below.
If select "Allow", all PCs will be denied to access Internet accept for the PCs
in the list below.
Fill in "Client PC MAC Address" and "Comment" of the PC that is allowed to
Add PC access the Internet, and then click "Add". If you find any typo before adding it
and want to retype again, just click "Reset" and the fields will be cleared.
If you want to remove some PC from the "MAC Filtering Table", select the
PC you want to remove in the table and then click "Delete Selected". If you
Remove PC
want remove all PCs from the table, just click "Delete All" button. If you want
to clear the selection and re-select again, just click "Reset".
Check "Enable IP Filtering Table" to enable IP filter.
If select "Deny", all PCs will be allowed to access Internet accept for the PCs
Enable IP Filtering Table in the list below.
If select "Allow", all PCs will be denied to access Internet accept for the PCs
in the list below.
You can click "Add PC" to add an access control rule for users by IP
Add PC
addresses.
If you want to remove some PCs from the "IP Filtering Table", select the PC
Remove PC
you want to remove in the table and then click "Delete Selected".
Delete All If you want to delete all PCs. Please click this button.
After configuration complete, please click "Apply" button to save the configuration. Then you will see a
screen to prompt you the settings are saving successfully. You may press "Continue" for configure other
settings or "Apply" to restart WNRT-625 with new configuration. Please refer to section 4.2.7 for more
information about this screen.
- 55 -