3.3.32 Guide rail (R) Assy
(1) Turn the AC power switch off. Unplug the AC power cord from the outlet.
(2)
Remove the main chassis unit (see 3.3.17).
(3)
Remove the insulator (see 3.3.29).
(4) Remove screw 1 and then remove base plate 2.
(5) Remove two screws 3 and then remove guide rail (R) Assy 4.
(6) Remove cassette lock spring 5 and then remove bias link 6 and pull block 7 (At this time, earth plate
8 is also removed.) (Pay attention the direction of hook of cassette lock spring 5.)
(7) Remove spring 9 and then remove cassette stopper 10.
(8) Remove screw A and then remove detector spring B.
(9) Remove screw C and then remove AOLS-PCB D.
(10) Remove screws E from bias link 6 and then remove link support F.
(11) Remove two screws G and then remove square cord from square-shaped connector H.
(12) Using great care, remove connector cord I from square-shaped connector H.
Service Guide OL1200
Chapter 3 Parts Replacement
Page: 67