4 Get started
Connect the baby unit to
power
You can connect the baby unit to a power
supply or insert non-rechargeable batteries to
operate it. Insert non-rechargeable batteries
to guarantee an automatic backup in case of
power supply failure.
1
Before you connect the baby unit to a
power supply, remove the lid of the battery
compartment.
2
Insert four non-rechargeable 1.5V R6 AA
batteries with the correct polarity (+/-) as
indicated.
3
Reattach the lid.
4
Connect a supplied adapter to the baby
unit and to a power supply.
10
EN
Charge the parent unit
Note
Make sure that the parent unit is disconnected from the
power supply and turned off.
1
Remove the lid of the battery
compartment.
2
Insert the supplied rechargeable battery
pack with the correct polarity (+/-) as
indicated.
3
Reattach the lid.
4
Connect a supplied adapter to the parent
unit and to a power supply to start
charging.
Tip
The battery pack only reaches the full capacity after
you charge it for four times.
)RU WKH ÀUVW WLPHV WKH FKDUJLQJ WLPH LV KRXUV DQG
the operating time is less than 24 hours.
The normal charging time is 8 hours, and the normal
operating time is 24 hours.
7KH EDWWHU\ LQGLFDWRU ÁDVKHV UHG DQG D EHHS RFFXUV
minutes before the battery pack runs out of power.