Operating Range; Change The Microphone Sensitivity; Eco Mode; Reset The Baby Monitor - Philips AVENT AVENT SCD505 User Manual

Operating range

‡ In normal mode:
‡ Outdoors: up to 1000 feet/330 meters
‡ Indoors: up to 150 feet/50 meters
‡ In ECO mode:
‡ Outdoors: up to 850 feet/260 meters
‡ The operating range varies depending on
the surroundings and other factors that
cause interference. For interference from
wet and moist materials, the range loss
is up to 100%. For interference from dry
materials, see the following table:
Dry materials
Wood, plaster, card-
board, glass (without
metal, wires, or lead)
Brick, plywood
Reinforced concrete < 12 in/30 cm 30-100%
Metal grilles or bars
Metal or aluminium
sheets
Change the microphone
sensitivity
You can change the microphone sensitivity of the
EDE\ XQLW 7KHUH DUH ÀYH OHYHOV $W OHYHO  WKH
baby unit can go to sleep mode if the surrounding
sound is continuously low and only a louder sound
can wake it. At level 5, the baby unit is in constant
monitoring mode and will not go to sleep mode.
1
Press sensitivity repeatedly on the parent
unit, to adjust the sensitivity according to
the environmental noise of the room.
» 7KH VRXQG OHYHO OLJKWV LOOXPLQDWH EULHÁ\
and indicate the current sensitivity
settings on the baby unit. If only one
light is on, the minimum sensitivity
LV VHOHFWHG ,I ÀYH OLJKWV DUH RQ WKH
maximum sensitivity is selected.
12 EN
Material Loss of
thickness range
< 12 in/30 cm 0-10%
< 12 in/30 cm 5-35%
< 0.4 in/1 cm 90-100%
< 0.4 in/1 cm 100%

ECO mode

When you monitor your baby from a small
distance, you can enable ECO mode. In ECO
mode, the baby monitor consumes less energy,
but still ensures that you can hear your baby
clearly without any distracting noise. For the
operating range in ECO mode, see Section
"Operating range".
Note
‡
Make sure that the parent unit is linked to the baby unit.
1
To enable ECO mode, press and hold
on the parent unit for two seconds.
» The ECO mode indicator lights up
blue and the parent unit reboots.
2
To disable ECO mode, press and hold
for two seconds.
» The ECO mode indicator goes out
and the parent unit reboots.

Reset the baby monitor

To reset the parent unit:
1
Press and hold
2
Press and hold
3
When you hold
» The parent unit is reset.
To reset the baby unit:
1
Follow the same procedure as you reset
the parent unit.
to turn off the parent unit.
on the parent unit.
, turn on the parent unit.