Citizen CL-S400DT User Manual page 36

Chapter 2 Printer Operation
Mode Settings
[Datamax® Emulation]
Top Menu Sub Menu
Cutter Action
Peel Wait Delay*
Paper Position
Menu Key Action
Interfaces
RS-232C Baud
RS-232C Parity
RS-232C Length
RS-232C Stop bit
[RS-232C Stopbit]
RS-232C X-ON
IEEE1284
* Only when cutter is mounted.
Default Menu
Backfeed Backfeed
Through
0.1 sec 0.1 to 2.0 sec
0.00 inch Peel/Cut/Tear Off
0.0 mm 0.00 to 2.00 inch
0.0 to 50.8 mm
Peel/Cut/Tear On
-1.00 to 1.00 inch
-25.4 to 25.4 mm
Enters Menu Enters Menu
Repeat Label Set
Repeat Last One
9600 115200
57600
38400
19200
9600
4800
2400
None None
Odd
Even
8 bits 8 bits
7 bits
1 bit 1 bit
2 bits
Yes Yes
No
On On
Off
36
Remarks
Sets the cutter action.
With the optional AutoConfigure On,
printing is executed only when the cutter
is installed or only when Cut is selected by
Function Select.
Backfeed is always set after cutting.
Through is set at the rear end of sheets 1 to
n-1 when the number of copies = n, and the
rear end of the final page of single sheet and
the copy is backfeed.
Sets the Peel Wait Delay.
Displays only machines with a peeler
installed.
Adjusts the stop position. It is based on the
inch/millimeter setting. There are initial
values of the stop position for each device
set above, and later, relative values are set.
Sets the menu key action.
Enters Menu:
Enters the menu setup mode.
Repeat Label Set:
Repeats the number of copies.
Repeat Last One:
Last one is issued only for the final page.
In the case of a count, afterwards, only
last one is issued.
Note: Hold down the MENU key for at least
4 seconds in order to enter the Menu Setup
Mode when setting the "Repeat Label Set" or
"Repeat Last One" menus.
Setting the baud rate of the serial interface.
• All settings related to the interface are
enabled after the power is reconnected.
Setting the communication parity for the
serial interface.
Setting the character length for the serial
interface.
Setting the stop bit for the serial interface.
Selectively setting the X-ON flow control of
the serial interface.
Setting both direction of the Centro
Interface.