Pride Mobility Travel Pal Owner's Manual page 25

V . B A T T E R I E S A N D C H A R G I N G
Battery Removal
1. Remove key from key switch.
2. Remove the seat by pulling it straight up and off of
the Travel Scooter.
3. Remove the detent pin and upper seat post. See
figure 14.
4. Position the Travel Scooter in a way that allows
access to the underside of the Travel Scooter and
remove the four (4) screws that secure the plastic
shroud to the frame. See figure 15.
5. Return the Travel Scooter to an upright position.
6. Remove the shroud and set it out of the way.
7. Disconnect the red (+) positive and black (-)
negative battery cables from the battery by pull-
ing them straight away from the battery terminal.
See figure 16.
8. Loosen the battery straps and remove the battery
or batteries to be replaced.
Battery Replacement
1. Put the new battery or batteries back onto the
Travel Scooter (battery terminals up) and secure
the battery straps.
2. Reconnect the two (2) battery cables to the bat-
tery terminals.
! Red cable to (+) positive terminal.
! Black cable to (-) negative terminal.
3. Reinstall the shroud back onto the Travel Scooter
frame.
4. Replace and tighten the screws that secure the
shroud to the frame.
5. Reinstall the upper seat post and detent pin.
6. Reinstall the seat.
NOTE: If you encounter a damaged or cracked
battery, immediately enclose it in a plastic bag
and call your authorised Pride Dealer for instruc-
tions on disposal. Your authorised Pride Dealer
will also have the necessary information on bat-
tery recycling, which is our recommended course
of action.
Travel Pal
Figure 14. Seat Post Removal
SECUREMENT SCREWS
Figure 15. Shroud Securement Screws
Figure 16. Battery Terminal Connections
www.pridemobility.com
UPPER SEAT POST
DETENT PIN
BATTERY TERMINALS
BATTERY CABLES
25