Terminal Block, Patch Panel (Bmp ® 21-Plus Only) - Brady BMP 21-PLUS User Manual

54
Terminal Block, Patch Panel (BMP
Selecting a Label Type
Terminal Block, Patch Panel
Terminal Block and Patch Panel label types are designed to be used with any media, except
SelfLam or Permasleeve. If SelfLam or Permasleeve is installed, these label types are not
available.
To use Terminal Block or Patch Panel:
1.
2.
Data fields display requesting additional information. (For a review of data field navigation,
see
1.
2.
If serialization is turned ON, proceed to Step 4.
BMP ® 21-PLUS/BMP ® 21-LAB User's Manual
®
21-PLUS only)
Press LABEL TYPE
Navigate to the desired label type and press Enter
page 19.) The data fields for Terminal Block and Patch Panel are similar.
Terminal Block data fields
In the Spacing: field, enter the amount of space that exists between the terminals or ports.
Note:
If you have indicated the correct spacing between the requested number of
terminals or ports, the printed label can be attached to the terminal block or patch
panel as one strip. There is no need to cut and adhere each individual block or port
identifier.
Navigate to the Serial: field, then use the left or right navigation key to turn serialization
ON or OFF.
Note:
If serialization is turned ON, you do not have to specify the number of
terminations (or the number of ports if using Patch Panel).
®
(BMP 21-PLUS only)
.
.
Patch Panel data fields