Table of Contents
Advertisement
The functions contained in MDrive are dis-
played:
>
"EDC"
Programs of the Electronic Damper
*
Control EDC
, refer to page
>
"DSC"
Dynamic Stability Control and
M Dynamic Mode, refer to page
>
"POWER"
Programs of the M Engine Dynamics
Control, refer to page
>
"Servotronic"
Servotronic, refer to page
You can reset all MDrive settings to their
default values:
>
"Reset to default"
5.
Select the desired function.
6.
Press the controller.
7.
Turn the controller to select the desired set-
ting.
"Unchanged" retains the current setting
made outside of MDrive.
8.
Press the controller.
The setting is stored for the remote control cur-
rently in use.
Online Edition for Part no. 01 41 0 014 699 - © 10/07 BMW AG
Activating the settings
Press the
78
in MDrive are active.
Pressing the button again deactivates MDrive.
76
respond because the Antilock Brake System
56
ABS or Dynamic Stability Control DSC are cur-
rently regulating driving stability. Press the
83
longer
You can change individual settings outside of
MDrive even when MDrive is activated, e.g.
using the buttons on the center console. To
reactivate all settings made on the Control Dis-
play for MDrive: press the
Key-dependent settings
For the remote control currently in use, you can
set your preferred program for the M Engine
Dynamics Control and Electronic Damper Con-
trol EDC. These presettings are called up when
the engine is started.
iDrive, for operating principle refer to page 16.
1.
2.
3.
button on the steering wheel.
The indicator lamp in the instrument
cluster comes on. The settings made
on the Control Display for the functions
If the indicator lamp flashes after the but-
ton was pressed, MDrive was unable to
button again when the indicator lamp is no
flashing.<
Press the
button.
This opens the start menu.
Press the controller to open the menu.
Select "M settings" and press the control-
ler.
button twice.
49
Advertisement
Table of Contents
