BMW 2007 M3 Owner's Manual page 215

Before using the M Mobility System, fol-
low the instructions on the sealant bot-
tle.<
Remove the label with the speed restriction
from the sealant bottle and apply it to the steer-
ing wheel.
Please note the expiry date on the sealant
bottle.<
Components of the M Mobility System
1 Sealant bottle and label with speed restric-
tion
2 Filling hose from sealant bottle to wheel
3 Connector and cable for the cigarette
lighter socket
4
Holder for the sealant bottle
5 Compressor
6 On/off switch
7 Pressure gauge for displaying the tire infla-
tion pressure
8 Screw on pressure gauge to reduce tire
inflation pressure
9 Hose to connect compressor and sealant
bottle or compressor and wheel
The connector, cable and connection hose are
stored in the compressor housing.
Online Edition for Part no. 01 41 0 014 699 - © 10/07 BMW AG
Using the M Mobility System
To repair a flat tire with the M Mobility System,
proceed as follows:
> Fill the sealant, refer to page 213.
> Distribute the sealant, refer to page 214.
> Produce the tire inflation pressure, refer to
page 214.
Filling the sealant
Strictly follow the specified sequence,
otherwise the sealant may escape under
high pressure.<
1. Shake the sealant bottle.
2. Screw hose 9 onto the connector of the
sealant bottle.
3. Ensure that screw 8 on the pressure gauge
is closed.
4. Unscrew the dust cap from the valve of the
defective wheel and screw filling hose 2 of
the sealant bottle onto the valve.
5. Insert the sealant bottle into the housing of
the compressor so that the bottle is upright.
6. Ensure that the device is switched off, posi-
tion 0.
7. Insert connector 3 into the cigarette lighter
socket in the interior of the vehicle, refer to
page 102.
8. With the ignition switched on:
Switch on the device and let it run for
approx. 3 minutes to fill the sealant. The
inflation pressure of the tire after filling is
unimportant.
9. Switch off the device.
10. Detach the hoses from the sealant bottle
connector and from the tire valve.
213