Installation; Removing The Unit - Boss Audio Systems BV7975 User Manual

Installation

INSTALLATION CAUTION
1. Before finally installing the unit, connect the
wiring temporarily and make sure it is all
connected properly and the unit and works
properly.
2. Use only the parts included with the unit to
ensure proper installation. The use of un-
authorized parts can cause mal functions.
3. Consult with your nearest dealer if install-
ation requires the drilling of holes or other
modifications of the vehicle.
4. Install the unit where it does not get in the
driver's way and cannot injure the
passenger if there is a sudden stop.
5. If installation angle exceeds 30° from
horizontal, the unit might not give its
optimum performance.
6. Avoid installing the unit where it would be
subject to high temperature, such as from
direct sunlight, or from hot air, from heater,
or where it would be subject to dust dirt or
excessive vibration.
7. Be sure to remove the front panel before
installing the unit.
Fitting the outer sleeve
Remove the transit screws
from the top of the car radio.
Remove the outer sleeve
and place into the
dashboard.
Make sure that it is not
angled more than 30°.
DON'T FORGET! Bend the metal tabs on the
outer sleeve outwards and downwards to stop
the sleeve from moving.
Fitting the support strap
Connect the fixing screw to the
rear of the car radio.
Bend the support strap to
suit the dashboard
aperture and fix to the
underside of the dash
board using the screw
Spring Washer
and washer.
and 5mm Nut
Slide the car radio into the
outer sleeve and connect the
spring washer and nut to the
fixingscrew.

Removing the unit

Insert fingers into the
groove in the front of frame
and pull out to remove
the frame.
Insert the levers supplied with
the unit into the grooves at
both sides of the unit as
shown in figure until
they click. Pulling the
levers makes it possible
to remove the unit from
the dashboard.
Din Rear-mount
Installation using the screw holes on the sides of
the unit.Fastening the unit to the factory radio
mounting bracket.
bracket
screw
NOTE: The mounting box, outer trim ring and
half-sleeve are not used for this method
installation.
Removing the detachable
front panel
30°
Press the panel release button
on the front panel.
DON'T FORGET!
Always turn off the
car radio before
removing the front
panel.
Attaching the detachable
front panel
Attach the front panel at the right
Screw and Washer
hand side first, and then push
the front panel forwards to
lock it securely into place.
Fixing Screw
NOTE: If the D.C.P is dirty,
wipe off the dirt with soft,
dry cloth only. And use a
cotton swab soaked in
isopropyl alcohol to clean
the socket on the back of
the D.C.P .
E - 3
Fra me
a
b
screw
dashboard
hook
hook
Panel Release
button
1
2