In-dash dvd/mp3/cd am/fm receiver with 3.2" (81mm) widescreen tft monitor with dual (front and rear) usb ports, sd memory card port and front panel av input (16 pages)
Page 3
BV7280 OWNER’S MANUAL Mobile Audio/Video System PLL Synthesizer Stereo Radio Automatic Memory Storing RBDS Operation Full Detachable Panel Preset Equalization Memory Card Interface USB Interface AV IN interface on the front panel Remote Control...
CONTENTS INSTALLATION.................. 3 USING THE DETACHABLE FRONT PANEL ........6 CONNECTIONS................. 7 LOCATIONS AND FUNCTION OF THE PLAYER ......8 LOCATIONS AND FUNCTION OF THE REMOTE CONTROL ..9 OPERATION ..................11 BASIC OPERATION..................12 USB PLAY OPERATION .................. 13 MEMORY CARD OPERATION.................
INSTALLATION Notes: Installing the unit Choose the mounting location where Be sure you test all connections first, and the unit will not interfere with the normal then follow these steps to install the unit. driving function of the driver. 1. Make sure the ignition is turned of f, and Before finally installing the unit, connect then disconnect the cable from the the wiring temporarily and make sure it...
Page 6
INSTALLATION (1) Metal Strap; (2) Mounting Bolt; (3) Hex Nut; (4) Spring Washer; (5) Tapping Screw; (6) Plain Washer 10. Reconnect the cable to the vehicle battery’s negative (-) terminal. Then replace the outer trim ring and install the unit’s front panel (see the steps of “To Install the front panel”).
Page 7
INSTALLATION Side View showing Screw Holes marked T, N or S Screw Factory Radio Mounting Bracket Screw Dashboard or Console To fasten the unit to the factory radio mounting brackets. Align the screw holes on the bracket with the screw holes on the unit, and then tighten the screws (5x5mm) on each side.
USING THE DETACHABLE FRONT PANEL Precautions when handling To Detach the Front panel 1. Do not drop the control panel. 1. Press the release button on the left-top of 2. Do not put pressure on the display or the panel and pull off the control panel. control buttons when detaching or re-installing the control panel.
LOCATIONS AND FUNCTION OF THE REMOTE CONTROL In audio file play mode, press to play all tracks in random order. Press it to turn on the unit. When the unit 10. VOL+/VOL- is on, press it to turn the unit off. Press to increase/decrease the volume 2.
LOCATIONS AND FUNCTION OF THE REMOTE CONTROL 21. ZOOM Press to allow the picture to be increased in size. 22. SELECT Press to enter into the system setup menu. 23. SEEK- / SEEK+ Press shortly to skip to the previous/next track.
OPERATION BASIC OPERATION ◆ Turn the unit on/off BRIGHTNESS When all the connection is finished, CONTRAST SHARTPNESS press MUT button on the front panel or COLOR on the remote control will turn the unit on. When the unit is on, hold press RESET MUT button or press to turn the unit...
OPERATION Pressing MUT button on the front function and some dat a will n ever lose even when power's off. You can press the panel or MUTE button on the remote numerical button 1, 3, 6 on the front panel control will mute the sound.
Page 16
OPERATION Shortly press again will return to the ◆ Multi-subtitle language function (For normal playback. Video file) Press SUB-T button on the remote ◆ Rapid forward / rapid reverse Hold press on the front panel control or SUB-T button on the front or hold press on the remote panel during playback.
Page 17
OPERATION 1) SYSTEM SETUP b) Press cursor When you open the setup menu, you buttons on the remote control to will see the system se tup page at first, select the items you want to program. see below: The items you selected will bec ome highlight.
OPERATION 3) AUDIO SETUP DIGITAL SETUP OP MODE When you open the AUDIO menu, DYNAMIC RANGE DUAL MONO you will see the following picture: AUDIO SETUP * OP MODE: to set the operating AUDIO OUT modes for Dolby Digital decoder, there are LINE OUT and RF REMOD to be selected.
OPERATION FM3, AM1 and AM2 band. The operation the audio/video/photo files in the card and is as below: start to play automatically. The operation is 1) Store in Memory the same with the USB operation described Press and hold desired radio preset above.
OPERATION AV IN OPERATION ◆ Local/Distant On the front panel of the unit, there is an Press LOC button on the remote control to AV IN jack. When you connected the select between local and distant stations. audio/video device from the jack, press Local setting for reception of strong MODE button on the remote control or station, and a distant setting for reception...
TROUBLE SHOOTING If it appears that your unit is faulty, first Nothing happens when the button are consult this checklist. It may be that pressed. something simple has been overlooked. An optional unit required to listen to each source is not connected yet. Under no circumstances should you try Connect the optional unit correctly.
SPECIFICATION GENERAL Power Supply Requirements DC 12 Volts, Negative Ground Maximum Output Power : 4x80 watts Current Drain : 15 Ampere (max.) Monitor Screen Size : 3.2” TFT RADIO Frequency Coverage 87.5 to 107.9 MHz (USA) 87.5 to 108 MHz (Europe/Asia) Sensitivity (S/N=30dB) 10 dBu Image Rejection...