Oki ES5430 User Manual page 50

3. Put the assembly down gently onto a piece of paper to prevent toner from marking
your furniture and to avoid damaging the green drum surface.
The green image drum surface at the base of the ID unit is very
delicate and light sensitive. Do not touch it and do not expose it to
normal room light for more than 5 minutes. If the drum unit needs
to be out of the printer for longer than this, please wrap the
cartridge inside a black plastic bag to keep it away from light.
Never expose the drum to direct sunlight or very bright room
lighting.
4. Note the positions of the four toner cartridges. It is essential that they go back in the
same order.
5. Slide the coloured release collar on the cartridge fully to the right hand side. This will
release the bond between the toner cartridge and the image drum unit.
6. Lift the right-hand end of the toner cartridge (1) and then draw the cartridge to the
right to release the left-hand end as shown (2), and withdraw the toner cartridge out
of the image drum cartridge. Place the cartridge on a piece of paper to avoid
marking your furniture.
7. Repeat steps
8. Take the new image drum cartridge out of its packaging and place it on the piece of
paper where the old cartridge was placed. Keep it the same way round as the old
unit. Pack the old cartridge inside the packaging material for disposal.
NOTE
Follow instructions that come with the new image drum for additional
information such as the removal of packaging material, etc.
9. Holding the toner cartridge by its top centre, lower it over the image drum unit.
10. Insert the left end of the cartridge into the top of the image drum unit first, pushing
it against the spring on the drum unit, then lower the right end of the cartridge down
onto the image drum unit. (It is not necessary to fit a new toner cartridge at this
time unless the remaining toner level is very low.)
5 and 6 for the remaining three cartridges.
Maintenance > 50
CAUTION!
1
2
3
4
2
1