How To Clear Bypassed Zones; How To Disarm The System - Honeywell Tuxedo User Manual

To bypass zones do the following:
ICON ACTION
1. From the "Home" screen, press the
SECURITY icon.
2. Press the MORE CHOICES icon.
3. Press the SHOW ZONES icon.
4. Highlight the zone(s) to be bypassed and
press the BYPASS SELECTED icon.
5. Enter your 4-digit user code.
6. Press the BACK icon to return to the
"Arming" screen.

How to Clear Bypassed Zones

A bypassed zone is automatically unbypassed when you disarm the system. If a zone is bypassed, you can remove the bypass as
follows:
ICON ACTION
1. Press the SHOW ZONES icon.
2. Press the CLEAR BYPASSES icon.
3. Enter your 4-digit user code. The "More
Choices" screen is displayed showing the
system as Ready to Arm.

How to Disarm the System

IMPORTANT: If you return to your home or business and the main burglary sounder is on, DO NOT enter the premises, but call
the police from a nearby safe location. If you return to your home or business after an alarm has occurred and the main sounder
has shut itself off, the keypad beeps rapidly upon entering, indicating that an alarm has occurred during your absence. LEAVE
IMMEDIATELY and CONTACT THE POLICE from a nearby safe location.
The system may be disarmed using either of two methods. One method is employed when you enter the premises and the other is
when you have been in the premises with the system armed (i.e., Stay and Night arming modes).
Security (cont'd)
Note: If any zones are bypassed or faulted, a Display Faults icon is also
displayed on this screen.
While the keypad is requesting and receiving the zone data from the control
panel, the screen displays "Please Wait!". Then the zones, along with their
current status, are displayed.
Note: If zones have already been bypassed, the top of this screen indicates
"Ready Bypass".
The screen is displayed with the instructions "To Bypass Zones, Enter Code".
The "More Choices" screen is displayed showing the system status as Ready-
Bypass.
While the keypad is requesting and receiving the zone data from the control
panel, the screen displays "Please Wait!". Then the zones, along with their
current status, are displayed.
Note: If the system is armed and you unbypass a zone, it disarms the system. If
zones are still faulted (not ready) the system will indicate the status as "Not Ready
Fault".
14
NOTES
NOTES