GE Profile Performance ADVANTIUM SCA2000BAA Service Manual page 37

FRONT GRILLE REMOVAL
Grille removal is required in order to lower the
control panel, remove the door, or gain access
to the line fuse, high voltage capacitor or high
voltage diode. To remove the grille follow these
steps:
1. Remove the two screws located above the
grille which secure the grille to the upper-
case and open the oven door.
2. Gently push down on the top of the grille
while rotating the top of the grille forward.
Note: the bottom of the grille has three
tabs which hinge into the oven frame.
3. Once the top grille screw plates have com-
pletely been removed from the cabinet,
lift upward on the grille, removing the three
MOUNTING
SCREW
FRONT
GRILLE
HV CAPACITOR AND DIODE REMOVAL
Prior to servicing the high voltage
CAUTION
capacitor or diode, remove power to the oven
(unplug it from it's receptacle or turn off circuit
breaker. Next, be sure to discharge the high volt-
age capacitor.
Once the front grille is removed you can access
the high voltage capacitor, high voltage diode and
20 amp line fuse.
SCREW
PLATE
MOUNTING
TAB
IMPORTANT NOTE:
which attach to the high voltage capacitor have
locking tabs on them. These tabs can not be
seen because they are encased in plastic. To
remove these terminals, use a pair of needle nose
pliers and grasp the top and bottom of the termi-
nal with the needle nose plier jaws. Gently
squeeze the plier jaws together while pulling the
electrical terminal from the capacitor.
DEPRESS LOCKING TAB
NOTE: TERMINAL END IS ENCASED IN CLEAR RUBBER
AND DOES NOT ALLOW YOU TO SEE LOCKING
TAB
Once the red and white high voltage transformer
leads are removed from the capacitor; the diode,
capacitor, and capacitor mounting bracket can
all be removed as one assembly.
THIS SCREW SECURES THE
CAPACITOR MOUNTING BRACKET
TO THE CHASSIS
REMOVING THE SCREW SHOWN ABOVE, ALLOWS
THE CAPACITOR & DIODE ASSY. TO BE REMOVED
– 35 –
CAPACITOR
DIODE
LINE FUSE
The electrical terminal ends
MOUNTING
BRACKET
+
CAPACITOR
DIODE