GE Profile Performance ADVANTIUM SCA2000BAA Service Manual page 10

B. OUTSIDE BACK EXHAUST
(Horizontal Duct)
This oven is shipped assembled for top exhaust.
Use the following steps to change it for outside
back exhaust.
1. Remove and save the screws that hold the
blower plate to the oven.
2. Slide the blower plate back from under its
retaining flange and lift it off.
• Remove and save the screw that holds the
blower motor to the oven.
Retaining Flange
3. • Carefully pull out the blower unit.
• The wires will extend far enough
to allow you to adjust the blower unit.
• Turn the blower unit end-over-end.
• Reroute the wires through the grooves on
the other side.
• Roll the blower unit so that the fan
blade openings are facing out the
back of the oven. The blower
unit exhaust openings should match
the exhaust openings on the rear of
the oven.
Blower Plate
BEFORE:
Fan Blade Openings Facing Up
Blower
Unit
End A
Grooves
AFTER:
Fan Blade Openings Facing Back
Grooves
Blower
Unit
End B
• The wires should be routed in the grooves
of the motor frame.
4. • Locate the two "knockout" plates, on the
rear oven panel, near the top of the oven.
• Using tin snips, carefully cut the web area
from the two holes side-by-side (that secure
the knockouts to the oven). Cut all four
webs on both rear knockouts; this will allow
the ventilation fan airflow to exhaust out
the rear of the oven.
CAUTION: Be sure to trim the sharp edges
from the openings after removing the
knockout plates.
– 8 –
End B
End A
Oven Rear Panel
Snip all 4 webs
on each knockout
panel and remove
the metal knockouts
for rear airflow.