GE Profile Performance ADVANTIUM SCA2000BAA Service Manual page 12

5
OVEN EXHAUST DUCT
4. • Guide the wires into the duct as you place
the blower unit back into the opening.
• Secure the blower motor to the oven
with the screw from Step 2.
CAUTION: Do not pull or stretch blower unit
wiring. Make sure wires are not pinched.
5. Replace the blower plate in the same position
as before, under its retaining flange, and
attach it with the screws.
Retaining
Flange
6. Install the Charcoal Filter. See the Owner's
Manual for the Charcoal Filter Accessory Kit
needed for this model.
• Remove the 2 screws on the top of the case
and remove the grille.
• Install the charcoal filter.
• Replace the grille and 2 screws.
Grille
7. Proceed to the PREPARATION OF TOP
CABINET section.
IMPORTANT—When installing the exhaust
blower in recirculation position, use Charcoal
Filter Accessor y Kit available from your
appliance dealer.
(continued)
Charcoal Filter
– 10 –
6
PREPARATION OF TOP CABINET
You need to drill holes for the top support
screws and a hole large enough for the power
cord to fit through.
• Read the instructions on the top cabinet
template.
• Tape it underneath the top cabinet.
• Drill and cut out the appropriate holes,
following the instructions on the template.
7
ATTACH THE MOUNTING PLATE
TO THE WALL
Your oven needs to be mounted against and
supported by a flat, vertical wall. Wall
construction should be a minimum of 2" x 4" wall
studding and 3/8" or more thick drywall or
plaster/lath. The oven must be attached to a
minimum of one 2" x 4" wall stud.
Usually
16" or 24"
1. Find the studs, using one of the following
methods:
A. Stud finder—a magnetic device which
locates nails.
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud installation.
After locating the stud(s), the center can be
found by probing the wall with a small nail to
find the edges of the stud and then placing a
mark halfway between the edges. The center
of any adjacent studs should be 16" or 24" from
this mark.
2. Draw a line down the middle of the studs.
THE OVEN MUST BE CONNECTED TO AT
LEAST ONE WALL STUD.
2" x 4"
Wall Stud
Drywall or
Plaster/Lath