Disabling Time Synchronization; Sntp: Viewing, Selecting, And Configuring - HP ProCurve 2610-PWR Management And Configuration Manual

Time Protocols

SNTP: Viewing, Selecting, and Configuring

Note that simply selecting a time synchronization protocol does not enable
that protocol on the switch unless you also enable the protocol itself (step 2,
above). For example, in the factory-default configuration, TimeP is the
selected time synchronization method. However, because TimeP is disabled
in the factory-default configuration, no time synchronization protocol is
running.

Disabling Time Synchronization

You can use either of the following methods to disable time synchronization
without changing the Timep or SNTP configuration:
■
■
SNTP: Viewing, Selecting, and
Configuring
SNTP Feature
view the SNTP time synchronization configuration
select SNTP as the time synchronization method
disable time synchronization
enable the SNTP mode (Broadcast, Unicast, or Disabled)
broadcast
unicast
none/disabled
configure an SNTP server address (for Unicast mode only) none
change the SNTP server version (for Unicast mode only)
change the SNTP poll interval
9-4
In the System Information screen of the Menu interface, set the Time
Synch Method parameter to None, then press [Enter], then [S] (for Save).
In the Global config level of the CLI, execute no timesync.
Default Menu
n/a page 9-5
timep page 9-6
timep page 9-6
disabled
n/a page 9-6
n/a page 9-6
n/a page 9-6
page 9-6
3 page 9-7
720 seconds page 9-7
CLI Web
page 9-8 —
page 9-9 ff. —
page 9-12 —
—
page 9-9 —
page 9-10 —
page 9-13 —
page 9-10 ff. —
page 9-12 —
page 9-12 —